Evaporative Emission (EVAP) Canister Replacement - 2

REMOVAL PROCEDURE




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the rear evaporative emission (EVAP) purge pipe (2) at the chassis EVAP purge pipe (3).




3. Disconnect the fuel tank EVAP pipe at the EVAP canister.




4. Disconnect the vent valve pipe (4) at the EVAP canister.




5. Remove the EVAP canister bracket to crossmember mounting bolt.
6. Remove the EVAP canister from the vehicle.
7. Remove the rear EVAP purge pipe from the EVAP canister and the retaining clip.
8. Remove the EVAP canister from the EVAP canister bracket.

INSTALLATION PROCEDURE




1. Install the new EVAP canister to the EVAP canister bracket.
2. Install the rear EVAP purge pipe to the EVAP canister and the retaining clip.
3. Install the EVAP canister to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the EVAP canister bracket to crossmember mounting bolt.

Tighten
Tighten the bolt to 25 N.m (18 lb ft).




5. Connect the fuel tank EVAP pipe to the EVAP canister.




6. Connect the rear EVAP purge pipe (2) to the chassis EVAP purge pipe.
7. Lower the vehicle.