Tilt Head Housing - Assemble

Steering Column Tilt Head Housing - Assemble - Off Vehicle

- Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42137 Cam Orientation Plate Adapter





1. Lubricate the following parts with synthetic grease:
- The inner race (1)
- The lower brass surface of the turn signal cancel cam assembly (4)
2. Install the following parts onto the steering column shaft assembly:
2.1. The inner race (1)
2.2. The upper bearing inner race seat (2)
2.3. The upper bearing spring (3)
2.4. The turn signal cancel cam assembly (4)
2.5. The cam orientation plate (5)





3. Install the new bearing retainer onto the steering column shaft assembly.
4. Compress the cam orientation plate using J 23653-SIR and J 42137.
Firmly seat the bearing retainer into the groove on the steering column shaft assembly.
5. Remove J 23653-SM from the steering column shaft assembly.
6. Install the inflatable restraint steering wheel module coil.
7. Enable the inflatable restraint steering wheel module.