Ignition & Key Alarm Switch - Disassemble

Ignition and Key Alarm Switch Assembly -Disassemble - Off Vehicle

- Tools Required
- J 42759 Ignition Switch Connector Release Tool

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the inflatable restraint steering wheel module.
2. Remove the upper and lower trim covers.

Important: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.

3. Remove the wire harness strap (2) from the steering column and the wire harness assembly (1).





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





5. Rotate the key alarm connector (1) 90 degrees.
6. Pull the key alarm connector (1) out of the electronic lock module assembly (2).
7. Remove the passkey connector from the electronic lock module assembly (2).





8. Insert J 42759 into the electronic lock module assembly (1) and slide the ignition and key alarm switch assembly (2) out.