10.5 Inch Axle

Locking Differential Disassemble (10.5 Inch Axle)

^ Tools Required
- J 22912-01 Split Plate Bearing Puller





1. Remove the differential assembly.
2. Remove the differential case bolts. Set the unit on the right side case half.
3. Remove the case halves.
3.1. Pry the halves apart at the yoke hole location.
3.2. Hold the side gear in the left side case half.
4. Remove the governor assembly.
5. Remove the latching bracket assembly.
6. Remove the left side gear.
7. Remove the left side clutch plates and the guide clips.
8. Remove the left side gear thrust washer.
9. Remove the following parts:
^ The reaction blocks
^ The pinion yoke
^ The pinion gears
^ The pinion thrust washers
10. Remove the right cam unit from the differential.
11. Remove the right side gear thrust washer. Measure and record the overall length of the gear assembly from the front of the gear to the back of the thrust sleeve including the side gear thrust washer.
12. Remove the thrust sleeve using the J 22912-01. Press the sleeve from the side gear.





13. Remove the clutch plates.
14. Remove the guide clips.
15. Remove the wave washer.
16. Remove the cam plate.
17. Remove the side cam gear.