10.5 Inch Axle

Pinion Depth Adjustment (10.5 Inch Axle)

1. Install the differential, if necessary.

Important: Measure and record the thickness of the pinion gear bearing retainer shim before any service procedures are performed to the pinion gear bearing retainer assembly.

2. Install the original shim to the pinion bearing retainer. If the original shim is not available; Install a 0.41 mm (0.016 inch) shim to build pinion depth.

Important: Do not apply sealant to the pinion gear bearing retainer at this time.

3. Install the pinion gear bearing retainer.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the pinion gear bearing retainer bolts.
^ Tighten the pinion gear bearing retainer bolts to 88 Nm (65 ft. lbs.).
5. Perform a gear tooth pattern check on the pinion and the ring gear.
6. If the gear tooth contact pattern indicates a high or a low flank contact pattern; adjust the pinion depth by doing the following:
6.1. Remove the pinion gear bearing retainer bolts.
6.2. Remove the pinion gear bearing retainer.
6.3. Remove the shim.
^ If the gear tooth contact pattern shows a high flank contact pattern: Install a shim one size larger.
^ If the gear tooth contact pattern shows a low flank contact pattern: Install a shim one size smaller.
6.4. Install the new shim to the pinion gear bearing retainer.
6.5. Install pinion gear bearing retainer.
6.6. Install pinion gear bearing retainer bolts.
^ Tighten the pinion gear bearing retainer bolts to 88 Nm (65 ft. lbs.).
6.7. Recheck the gear tooth contact pattern of the pinion and the ring gear.
6.8. If the gear tooth pattern is still incorrect; adjust the shim thickness as necessary; and recheck the gear tooth pattern of the pinion and the ring gear.





The pinion shims are available in the following sizes: