Turn Signal & Multifunction Switch - Disassemble

Turn Signal and Multifunction Switch Assembly - Disassemble Off Vehicle

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the inflatable restraint steering wheel module.
2. Remove the upper and lower trim covers.

Important: The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.

3. Remove the wire harness assembly (1) from the wire harness strap (2).
4. Disconnect the turn signal and multifunction switch assembly connector from the inflatable restraint steering wheel module coil connector.





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





6. Remove the 2 pan head tapping screws (1) and (3) from the turn signal and multifunction switch assembly (2).
7. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly.