Electronic Column Lock Module

Electronic Column Lock Module Replacement (Floor Shift)

- Tools Required
- J 23653-SIR Steering Column Lock Plate Compressor
- J 42759 Ignition Switch Connector Release Tool

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.

Important: Remove the SIR coil from the steering shaft and let the SIR coil hang freely.

2. Remove the SIR coil.
3. Install the J 23653-SIR to the steering shaft and compress the shaft lock shield.
4. Remove the lock shield retainer from the steering column shaft.
5. Remove the J23653-SlR from the steering shaft.





6. Remove the following parts from the steering shaft:
6.1. The shaft lock shield (4)
6.2. The turn signal cancel cam (3)
7. Rotate the steering column lock cylinder to the OFF-LOCK position.





8. Disconnect the electric park lock (1) electrical connector (2).





9. Unsnap the electric park lock (2) off of the electronic lock module (1).





10. Rotate the key alarm switch connector from the electronic lock module.
11. Disconnect the passlock electrical connector from the electronic lock module.





12. Remove the ignition lock cylinder.
13. Disconnect the ignition switch (2) from the electronic lock module using the J 42759.
14. Remove the ignition switch (2) from the electronic lock module (2).
15. Let the ignition switch (2) hang freely.





16. Remove the electronic lock module (1) mounting screws (2).
17. Remove the electronic lock module (1) from the steering column housing.

Installation Procedure





1. Install the electronic lock module (1) to the steering column housing.
2. Install the electronic lock module (1) mounting screws (2).





3. Install the ignition switch (2) to the electronic lock module (2).
4. Install the ignition lock cylinder.





5. Connect the passlock electrical connector (1) from the lock module
6. Rotate the key alarm switch connector to the electronic lock module.





7. Snap the electric park lock (2) onto the electronic lock module (1).





8. Connect the electric park lock (1) electrical connector (2).





9. Install the following parts to the steering shaft:
9.1. The turn signal cancel cam (3)
9.2. The shaft lock shield (4)





10. Install the J 23653-SIR to the steering shaft and compress the shaft lock shield.
11. Install the lock shield retainer to the steering column shaft.
12. Remove the J23653-SIR from the steering column shaft.
13. Install the SIR coil.
14. Enable the SIR system.