106. Rear Cover Installation

Rear Cover Installation





Important: Except as noted, a transfer case adapter housing is installed using the same procedures as used when installing a rear cover.

1. Install a new gasket (2) onto main housing (3).
2. For a two-wheel drive transmission, make sure the output shaft turns with the tone wheel.
3. Align the rear cover or adapter housing with main housing dowel pin (4) and park pawl pin (5).
4. Install the rear cover or adapter housing.
5. For a two-wheel drive transmission, turn the output tone wheel through the output speed sensor hole to make sure the output shaft turns with the tone wheel.





6. Hand install four bolts (1).
7. Evenly draw down bolts (1) until the rear cover or adapter housing seats on the main housing.
8. Hand install twelve bolts (2).

Notice: Refer to Fastener Notice in Service Precautions.

9. Tighten bolts (1) and (2).
Tighten bolts (1) and (2) to 56 Nm (42 ft. lbs.).