Instrument Panel Cluster (IPC) - Bezel Replacement

Bezel Replacement - IP Cluster

Removal Procedure




1. For vehicles equipped with tilt wheel, move the steering column to the lowest position. If the vehicle is not equipped with a tilt steering column, you may have to lower the column. Refer to Steering Column Replacement in Steering Wheel and Column.
2. Remove the 4 clips across the top edge, and the 4 clips across the bottom edge that retain the bezel to the IP by gently pulling toward the inside of the vehicle.
3. Disconnect the electrical connectors from the headlamp switch and the accessory switches.

Installation Procedure




1. Connect the electrical connectors for the headlamp switch and the accessory switches.
2. Press the bezel into the IP making sure that the clips line up with the holes in the IP.
3. Install the steering column back into position.