Dome Lamp: Service and Repair

REMOVAL PROCEDURE




1. Remove the lens (5).
2. Remove the bulb (2).
3. Remove the housing screws (6).
4. Remove the lamp assembly (4).
5. Disconnect the electrical connector (1).
6. Remove the bezel (3).

INSTALLATION PROCEDURE




1. Install the bezel (3).
2. Connect the electrical connector (1).
3. Install the lamp assembly (4).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the housing screws (6).

Tighten
Tighten the screws to 2 N.m (18 lb in).

5. Install the bulb (2).
6. Install the lens (5).