Base With Composite

REMOVAL PROCEDURE




1. Make sure the headlamp switch is in the OFF position.
2. Remove the screws.
3. Remove the park/turn signal lamp assembly.
4. Disconnect the electrical connector.
5. Remove the bulbs from the assembly.

INSTALLATION PROCEDURE




1. Install the bulbs to the park/turn signal lamp assembly.
2. Install the lamp assembly.
3. Connect the park/turn signal lamp connector.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the screws.

Tighten
Tighten the screws to 2 N.m (18 lb in).