Ignition & Key Alarm Switch - Disassemble

Ignition and Key Alarm Switch Assembly-Disassemble-Off Vehicle (Floor Shift)
1. Remove the upper and lower trim cover.





2. Pop the wire harness assembly (4) out of the wire harness strap (5).
3. Remove the wire harness straps (3) from the wire harness assembly (4).
4. Remove the wire harness strap (2) from the upper tilt head assembly (1).





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out from the bulk head connector (1).





6. Remove the key alarm connector (1) from the lock module assembly (2).
7. Remove the 2 tapping screws from the ignition key alarm switch assembly (3) and remove.