Clutch Assembly Replacement

Clutch Assembly Replacement

- Tools Required
- J 5824-01 Clutch Alignment Tool
- J 44747 Clutch Alignment Arbor

Removal Procedure





1. Remove the manual transmission.
2. Remove the clutch pressure plate bolts.

Important: Dowel pins are used to align the flywheel and pressure plate. When removing the pressure plate check to see if the dowel pins are rusted into the pressure plate, if so remove, clean, and reinstall the dowel pins into the correct locations on the flywheel.

3. Remove the clutch pressure plate and driven plate from the dowel pins.

Installation Procedure





1. Install the clutch pressure plate and driven plate to the dowel pins.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install J 44747 to align the clutch.
3. Install the clutch pressure plate bolts.
- Tighten the clutch pressure plate bolts to 70 Nm (52 ft. lbs.).
4. Remove the J 5824-01.
5. Install the manual transmission.