Crankshaft, Engine

Crankshaft Bearing Cap Bolts (Inner Bolts-First Pass in Sequence) 20 Nm (15 ft. lbs.)
Crankshaft Bearing Cap Bolts (Inner Bolts-Final Pass in Sequence) 80 degrees
Crankshaft Bearing Cap Bolts (Outer Bolts-First Pass in Sequence) 20 Nm (15 ft. lbs.)
Crankshaft Bearing Cap Bolts (Outer Bolts-Final Pass in Sequence) 51 degrees
Crankshaft Bearing Cap Side Bolts 25 Nm (18 ft. lbs.)
Crankshaft Oil Deflector Nuts 25 Nm (18 ft. lbs.)
Crankshaft Bearing Clearance (Production) 0.020-0.052 mm (0.0008-0.0021 inch)
Crankshaft Bearing Clearance (Service) 0.020-0.065 mm (0.0008-0.0025 inch)
Crankshaft Connecting Rod Journal Diameter (Production) 53.318-53.338 mm (2.099-2.1 inch)
Crankshaft Connecting Rod Journal Diameter (Service Limit) 53.308 mm Minimum (2.0987 inch Minimum)
Crankshaft Connecting Rod Journal Taper (Production) 0.005 mm Maximum for one half of the Journal Length (0.0002 inch (Maximum for one half of the Journal Length)
Crankshaft Connecting Rod Journal Taper (Service Limit) 0.02 mm Maximum (0.00078 inch Maximum)
Crankshaft Connecting Rod Journal Out-of-Round (Production) 0.005 mm (0.0002 inch)
Crankshaft Connecting Rod Journal Out-of-Round (Service Limit) 0.01 mm (0.0004 inch)
Crankshaft End Play 0.04-0.2 mm (0.0015-0.0078 inch)
Crankshaft Main Journal Diameter (Production) 64.993-65.007 mm (2.558-2.5593 inch)
Crankshaft Main Journal Diameter (Service Limit) 64.993 mm Minimum (2.558 inch Minimum)
Crankshaft Main Journal Out-of-Round (Production) 0.003 mm (0.0001 inch)
Crankshaft Main Journal Out-of-Round (Service Limit) 0.008 mm (0.0003 inch)
Crankshaft Main Journal Taper (Production) 0.01 mm (0.0004 inch)
Crankshaft Main Journal Taper (Service Limit) 0.02 mm (0.00078 inch)
Crankshaft Reluctor Ring Runout (Measured 1.0 mm (0.04 inch) Below the Tooth Diameter 0.7 mm Maximum (0.028 inch Maximum)
Crankshaft Runout (at Rear Flange) 0.05 mm Maximum (0.002 inch Maximum)
Crankshaft Thrust Wall Runout 0.025 mm (0.001 inch)
Crankshaft Thrust Wall Width (Production) 26.14-26.22 mm (1.029-1.0315 inch)
Crankshaft Thrust Wall Width (Service) 26.2 mm Maximum (1.0315 inch Maximum)
Main Bearing Bore Diameter (Production) 69.871-69.889 mm (2.750-2.751 inch)
Main Bearing Bore Diameter Out-of-Round 0.006 mm (0.0002 inch)