Tie Rod Replacement

Tie Rod Replacement

^ Tools Required
- J 24319-B Universal Steering Linkage Puller
- J 29194 Steering Linkage Installer-14 mm

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.

Important: Use the J 24319-B in order to separate all the tie rods and ball joints.

2. Remove the nut (2) from the outer tie rod ball stud (3).





3. Use the J24319-B in order to remove the outer tie rod ball stud from the steering knuckle.

Important: Do not reuse the nut.

4. Remove the tie rod end from the shaft by loosening the jam nut.





5. Remove the outer tie rod end from the relay rod.
6. Inspect the shaft (6) for bent or damaged threads.
7. Clean the tapered surface of the steering knuckle (1).

Installation Procedure





1. Lubricate the tie rod threads with chassis lubricant.
2. Install the tie rod end (4) to the shaft (6).
3. Install the outer tie rod ball stud (3) to the steering knuckle (1).

Notice: Refer to Fastener Notice in Service Precautions.





4. Use the J 29194 in order to install the outer tie rod ball stud.
^ Tighten the J 29194 to 54 Nm (40 ft. lbs.) in order to seat the tapers.





5. Install the new prevailing torque nut (2) to the outer rod ball stud (3).
^ Tighten the nut to 65 Nm (48 ft. lbs.).
6. Adjust the front toe.
7. Tighten the jam nut (5).
^ Tighten the nut to 65 Nm (48 ft. lbs.).