Liftgate - License Plate Housing Paint Rubs Through
File In Section: 08 - Body and AccessoriesBulletin No.: 02-08-66-004
Date: April, 2002
TECHNICAL
Subject:
Paint Rub Through on Liftgate Around Edge of License Plate Housing/Pocket (Install Insulating Seal/Gasket)
Models:
2002 Chevrolet and GMC S/T Utility Models (TrailBlazer, Envoy)
2002 Oldsmobile Bravada
Condition
Some customers may comment that the paint on the liftgate around the edges of the license plate housing or pocket appears to be rubbing through or wearing off.
Cause
Changes in temperature may cause the plastic license plate housing to expand and contract. When this occurs, the license plate housing comes in contact with or rubs against the paint surface on the liftgate.
Correction
Remove the license plate housing from the liftgate. Refer to the License Plate Pocket Replacement procedure in the Service Manual (SI2000 Document ID # 740995). Install an insulating perimeter seal or gasket on the backside edge of the housing as shown. When properly installed, the seal (1) will start at one side of the liftgate release handle (2) and go completely around the housing stopping at the other side of the handle. Do NOT attempt to install the seal on the liftgate housing directly below the release handle. Once installed, it may be necessary to trim off any excess seal material.
Parts Information
Parts are expected to be available 4-22-2002 from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table shown.
DISCLAIMER