Inflatable Restraint Sensing and Diagnostic Module

INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to SIR Caution in Service Precautions.




1. Disable the SIR system. Refer to Air Bag(s) Arming and Disarming.
2. Remove the floor console.
3. Partially remove the console mounting bracket in order to allow access to the rear carpet. Refer to Bracket Replacement - Console Floor in Instrument Panel, Gages, and Console.
4. Position the rear carpet in order to access the sensing and diagnostic module (SDM).
5. Disconnect the electrical connectors (2) from the SDM (1).




6. Remove the nuts that retain the SDM to the floor panel.
7. Remove the SDM from the vehicle.

INSTALLATION PROCEDURE




1. Install the SDM to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the nuts that retain the SDM to the floor panel.

Tighten
Tighten the nuts to 12 N.m (106 lb in).




3. Connect the electrical connectors (2) to the SDM (1).
4. Return the carpet to the fully installed position.
5. Install the console mounting bracket to the floor panel.
6. Install the floor console.
7. Enable the SIR system. Refer to Air Bag(s) Arming and Disarming.