Procedures

AIR CLEANER ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE




1. Turn OFF the ignition.
2. Disconnect the mass air flow/intake air temperature (MAF/IAT) sensor assembly harness connector.




3. Separate the MAF/IAT sensor assembly and the air inlet tube by loosening the hose clamp.




4. Remove the air cleaner assembly by pulling upward until the mounting studs are free from the assembly grommets.

INSTALLATION PROCEDURE




1. Install the air cleaner assembly by pressing downward on the assembly until the grommets are seated.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Connect the MAF/IAT sensor assembly and the air inlet tube by tightening the hose clamp.

Tighten
Tighten the clamp to 4 N.m (35 lb in).




3. Connect the MAF/IAT sensor assembly harness connector.