9.75 Inch Axle

Differential Side Bearings Replacement (9.75 Inch Axle)

^ Tools Required
- J 22888-D Side Bearing Remover Kit
- J 24430 Differential Side Bearing Installer
- J 45711 Differential Side Bearing Remover -Dana 248
- J 29710 Differential Side Bearing Installer
- J 45900 Differential Side Bearing Installer -Dana Axles
- J 8092 Universal Driver Handle - 3/4 in - 10

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the axle shafts.
3. Remove the differential assembly.
4. Remove the differential side bearing by performing the following steps:
^ Install the J45711 (2) and the J8107-3 (1) as shown.
^ Remove the differential side bearing using the J 45711 and a hydraulic press.

Important: Mark the inboard shims left or right.

5. Remove the inboard shims.

Installation Procedure





1. Determine the shim thickness and preload for the differential assembly.
2. Install the differential side bearing by doing the following:
2.1. In order to protect the differential case, install the J 8107-3 in the case on the side opposite of the bearing installation.
2.2. Install the inboard shires.
2.3. Install the differential side bearing.
2.4. Install the J 24430 or the J 45900 (2) and the J 8092 (1) over the differential side bearing.
2.5. Drive the differential side bearing into position using the J 24430 or the J 45900 and the J 8092.
2.6. Install the differential assembly.
3. Install the axle shafts.
4. Fill the axle with lubricant. Use the proper fluid.
5. Lower the vehicle.