Engine Sight Shield Replacement

Engine Sight Shield Replacement (4.8L, 5.3L, and 6.0L (LQ4)

Removal Procedure





1. Loosen the intake manifold sight shield bolt.
2. Remove the sight shield from the sight shield retainer.





3. If removal of the sight shield retainer is required, disconnect the accelerator control cable clip from the retainer.





4. Disconnect the cruise control cable clip from the retainer.
5. Remove the sight shield retainer bolts and the retainer, if required.

Installation Procedure





Notice: Refer to Fastener Notice in Service Precautions.

1. Install the sight shield retainer and the bolts, if required.
- Tighten the retainer bolts to 5 Nm (44 inch lbs.).
2. Install the cruise control cable clip to the retainer.





3. Install the accelerator control cable clip to the retainer.





Notice: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
4. Install the intake manifold sight shield to the retainer.
- Tighten the bolt to 10 Nm (89 inch lbs.).