Rear Window Replacement

Rear Window Replacement

Tools Required
* J 24402-A Glass Sealant Cold Knife Remover
* J 39032 Stationary Glass Removal Tool
* J 34940 Rivet Gun
* Urethane Adhesive Kit GM P/N 12346392 or Equivalent
* Isopropyl Alcohol or Equivalent
* Cartridge-type Caulking Gun
* Commercial-type Utility Knife
* Razor Blade Scraper
* Suction Cups
* Plastic Paddle

Removal Procedure

Caution: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.

Important: Before cutting out a window, apply a double layer of masking tape around the perimeter of the painted surfaces and the interior trim.

1. Remove the window garnish molding from the door frame.




2. Disconnect the electrical connector from the window defogger, if equipped.




Caution: Refer to Cracked Window Caution in Service Precautions.

Important: Keep the cutting edge of the tool against the rear window. This will allow the urethane adhesive to be separated from the window.

3. Use J 24402-A, J 39032, or equivalent in order to remove the rear window.

* Leave a base of urethane on the pinchweld flange.
* The only suitable lubrication is clear water.




4. With the aid of an assistant, remove the window from the opening.

Installation Procedure

1. Install the stationary window into the opening




2. Connect the electrical connector to the window defogger, if equipped.
3. Install the window garnish molding to the door frame.
4. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.