Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE




1. Remove the starter.
2. Disconnect the crankshaft position (CKP) sensor electrical connector.

Crankshaft Position Sensor (CKP):

3. Clean the area around the CKP sensor before removal, in order to avoid debris from entering the engine.
4. Remove the CKP sensor bolt.
5. Remove the CKP sensor.

INSTALLATION PROCEDURE

Crankshaft Position Sensor (CKP):

1. Install the CKP sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor bolt.

Tighten
Tighten the bolt to 25 N.m (18 lb ft).




3. Connect the CKP sensor electrical connector.
4. Install the starter.
5. Perform the CKP system variation learn procedure. Programming and Relearning