Steering Column Trim Covers - Assemble

Steering Column Trim Covers - Assemble -Off Vehicle (Floor Shift)





1. Install the upper trim cover (2) onto the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 TORX (R) head screws (1) into the upper trim cover (2).
- Tighten the 2 TORX (R) head screws to 1.5 Nm (13 inch lbs.).





3. Install the lower trim cover onto the upper trim cover in the following way:
3.1. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
3.2. Tilt the lower trim cover up.
3.3. Slide the lower trim cover forward until the locking tabs snap into the tab slots.





4. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).
- Tighten the 2 pan head tapping screws to 3.5 Nm (31 inch lbs.).
5. Install the tilt lever into the lower trim cover.
6. Install the steering wheel onto the steering column.
7. Enable the inflatable restraint steering wheel module.