Cylinder Head Assembly: Specifications

This article has been updated with TSB 06-06-01-006B

Fastener Tightening Specifications











General











Overhaul

Engine Mechanical Specifications





General























Overhaul





Connecting Rod Bearings Selection Specifications

Please Refer To TSB #06-06-01-006b For Update Info:

Cylinder Head Gasket Selection Specifications





Crankshaft Bearings Selection Specifications





Valve Clearance Adjustment Specifications

Tightening Sequence

Cylinder Head Tightening Sequence:

Cylinder Head

Install the NEW M12 cylinder head bolts. Reuse the M8 bolts.
Tighten the M12 cylinder head bolts in three steps:
- 1st step 50 Nm (37 ft. lbs.)
- 2nd step 80 Nm (59 ft. lbs.)
- 3rd step tighten 60 degrees using J 36660-A
- 4rd step tighten 60 degrees using J 36660-A
- Tighten the M8 cylinder head bolts to 25 Nm (18 ft. lbs.).





Intake Manifold





Intake Manifold Tube Installation (Federal Emissions)





Intake Manifold Tube Installation (California Emissions





Exhaust Manifold





Engine Flywheel Automatic Transmission

Tighten the flywheel bolts in the proper sequence.
- 1st step 79 Nm (59 ft. lbs.).
- 2nd step 60 degrees using J 36660-A.
- 3rd step 60 degrees using J 36660-A.

Engine Flywheel Manual Transmission





- Tighten the flywheel bolts to 78 Nm (58 ft. lbs.).
- Tighten the flywheel bolts to 60 degrees using the J 36660-A.
- Tighten the flywheel bolts again to 60 degrees using the J 36660-A.

Thread Repair Specifications





Cylinder Head - Exhaust Port View





Cylinder Head - Intake Port View








Cylinder Head - Top View





Cylinder Head - Back View





Cylinder Head - Front View