Transfer Case Assembly Replacement

Transfer Case Assembly Replacement

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shields.
3. Remove the front propeller shaft.
4. Remove the rear propeller shaft.





5. Remove the motor/encoder electrical connector.





6. Remove the transfer case vent hose.





7. Remove the transfer case electrical wiring harness.

Important: Make sure that the transfer case is properly secured to the transmission jack.

8. Support the transfer case with a suitable transmission jack.





Important: When removing the NVG 246 transfer case from the transmission, it is not necessary to remove the transmission mount or the transfer case adapter in order to remove the transfer case.

9. Remove the transfer case retaining nuts from the transfer case studs.





10. Separate the transfer case from the transmission by moving it straight back toward the rear of the vehicle.
11. Rotate the transfer case so that it is perpendicular to the transmission assembly.
12. Lower the transfer case.

Installation Procedure





1. Rotate the transfer case so that it is perpendicular to the transmission assembly.
2. Raise the transfer case into position.
3. Rotate the transfer case so that it is aligns with the transfer case adapter.
4. Install the transfer case assembly.





Notice: Refer to Fastener Notice in Service Precautions.

5. Install the transfer case retaining nuts.
^ Tighten the transfer case retaining nuts to 50 Nm (37 ft. lbs.).





6. Install the transfer case vent hose.





7. Install the transfer case electrical wiring harness.





8. Install the motor/encoder electrical connector.
9. Install the front propeller shaft.
10. Install the rear propeller shaft.
11. Check the transfer case fluid level.





12. Install the transfer case shield.
13. Lower the vehicle. Refer to Vehicle Lifting.