84. P3 Planetary Carrier Bearing Race Replacement
P3 Planetary Carrier Bearing Race ReplacementTools Required
^ J44528 P3 Carrier Bearing Race Remover
^ J43797 P3 Carrier Bearing Race Installer
Removal Procedure
1. Position the P3 planetary carrier (2) on the work table so that the rear of the carrier is facing up.
2. Install J44528-1 (1) over the hub of the carrier and onto the bearing race (3).
3. Tighten the J44528-1 screws (4) wrench tight.
4. Place 2 wooden blocks (3) on the press. Install J44528-2 (1) into the carrier.
5. Position the carrier (4) so that J44528-1 (2) spans the wooden blocks and the front of the carrier is facing down.
Caution: Pressing the P3 planetary carrier from the bearing race causes the P3 carrier to fall from the bearing race. Make sure the P3 carrier is safely caught when freed from the bearing race. An uncontrolled P3 carrier could cause personal injury and/or property damage.
6. Using J44528-2 (1), press the P3 planetary carrier (4) from J44528-1 (2).
7. Remove the bearing race from J44528-1.
8. Remove J44528-2 (1) from the carrier.
Installation Procedure
1. Position the P3 planetary carrier (3) on the press so that the rear of the carrier is facing up.
2. Install a new bearing race into J43797 (1).
3. Using J43797 (1), press the bearing race (2) onto the P3 planetary carrier (3) until J43797 seats.