Instrument Panel (IP) - Lamp Replacement

IMPORTANT: This procedure calls for the replacement of incandescent bulbs only. The light emitting diodes (LEDs) are not replaceable individually. If a LED replacement is needed, replace the entire instrument panel cluster (IPC).

Removal Procedure

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Remove the IPC.
3. Unclip the IPC rear cover plate by prying gently on the tabs with a screwdriver.




4. Remove the rear cover plate from the IPC.




5. Remove the bulb and base assembly by turning the bulb 1/2 turn counterclockwise and pulling outward.

Installation Procedure




1. Install the bulbs into the cluster by inserting the bulb and base assembly, and turning the bulb 1/2 turn clockwise.




2. Carefully snap the rear cover plate to the IPC.
3. Install the IPC.
4. Connect the negative battery cable.