Air Temperature Actuator

The instrument panel fuse block provides power to the air temperature actuator through the ignition 3 voltage circuit. Power and ground are provided to the HVAC control assembly by the ignition 3 voltage, ground circuits and splice pack.

When a desired temperature setting is selected, a variable resistor is used to determine the air temperature actuators setting. The resistor is located within the HVAC control assembly. Turning the temperature switch will vary the 12-volt signal. That varied 12-volt signal is sent to the servo amplifier inside the air temperature actuator on the air temperature door position signal circuit. The motor opens the air temperature door to a position to divert sufficient air past the heater core or evaporator to achieve the desired vehicle temperature. The air temperature actuator is grounded through the ground circuit and splice pack.

When servicing an actuator, replace parts with the correct service parts for the actuator being serviced. The electric actuators for the manual HVAC system (C42 and C60) have a red R on top of them. This is to differentiate from the electric actuators used on the automatic HVAC system (C68).

For a description of the RPO Code(s) shown in this article/images refer to the RPO Code List found at Vehicle/Application ID RPO Codes