Ignition Switch

Ignition Switch Replacement- On Vehicle

^ Tools Required
- J 42759 Ignition Switch Connector Reel Tool

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.
2. Remove the knee bolster.
3. Remove the steering column trim covers from the steering column.
4. Disconnect the steering column bulkhead electrical connectors.





5. Remove the wire harness (1) from the wire harness strap (2) and the steering column.





6. Slide the connectors (2) of the turn signal and multifunction switch out of the bulkhead connector (1).





7. Remove the key alarm connector (1) from the lock module (2) in the following way:
7.1. Rotate the key alarm connector (1) 90 degrees.
7.2. Pull the key alarm connector (1) out of the lock module (2).
7.3. Remove the passkey electrical connector from the lock module (2).





8. Disconnect the electrical connector (2) from the electric park lock (1), for vehicles equipped with floor shifters.
9. Disengage the ignition switch releasing tabs by using J 42759.





10. Remove the ignition switch (2) from the lock module (1).

Installation Procedure





1. Install the ignition switch (3) into the lock module (1).





2. Install the key alarm connector (1) into the lock module (2).
2.1. Push the key alarm connector (1) into the lock module (2).
2.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
2.3. Install the passkey electrical connector to the lock module (2).





3. Connect the electrical connector (2) to the electric park lock (1), for vehicles equipped with floor shifters.





4. Slide the connectors (2) of the turn signal and multifunction switch into the bulkhead connector (1).





5. Attach the wire harness (1) to the steering column with the wire harness strap (2).





6. Connect the steering column bulkhead electrical connectors to the vehicle.
7. Install the trim covers to the column.
8. Install the knee bolster.
9. Enable the SIR system.