Transmission Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the vehicle speed sensor electrical connector.
3. Remove the vehicle speed sensor retaining bolt.
4. Remove the vehicle speed sensor.

Installation Procedure





1. Install the new O-ring seal to the vehicle speed sensor.
2. Coat the new O-ring seal with a thin film of transmission fluid.
3. Install the vehicle speed sensor.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the vehicle speed sensor retaining bolt.
^ Tighten the vehicle speed sensor retaining bolt to 16 Nm (12 ft. lbs.).
5. Connect the vehicle speed sensor electrical connector.
6. Lower the vehicle.