Front Coil Spring Replacement
Front Coil Springs Replacement^ Tools Required
- J 23028-01 Coil Spring Remover and Installer
Removal Procedure
Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.
1. Remove the stabilizer shaft link from the lower control arm.
2. Remove the shock absorber.
3. Secure J 23028-01 to the end of a suitable jack.
4. Cradle the lower control arm bushings using J 23028-01.
5. Raise the jack in order to relieve tension on the lower control arm pivot bolts.
6. Turn the steering wheel to one side in order to allow the steering linkage to clear the lower control arm front pivot bolt.
7. Remove the lower control arm pivot bolts and nuts.
7.1. Remove the lower control arm rear pivot bolt.
7.2. Remove the lower control arm front pivot bolt.
8. Lower J 23028-01 slowly to relieve the tension from the front coil spring.
9. Remove the front coil spring and the insulators. While removing the front coil spring, do not apply force to the lower control arm and/or lower ball joint.
Installation Procedure
1. Install the front coil spring and the insulators on the lower control arm.
Ensure that front coil spring covers all or part of one inspection drain hole. The other hole must be partly or completely uncovered. Rotate coil spring as necessary.
2. Support the control arm using J 23028-01.
3. Position the coil spring and insulator in the upper spring seat on the frame.
4. Raise the lower control arm using J 23028-01.
5. Install the lower control arm to the frame.
6. In order to maintain adequate steering linkage clearance, install the bolts in the direction shown.
7. Install the lower control arm front pivot bolt and the new nut.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the lower control arm rear pivot bolt and the new nut.
8.1. Tighten the lower control arm pivot bolts nuts with the front suspension loaded.
8.2. Tighten the lower control arm front bolt to 115 Nm (85 ft. lbs.).
8.3. Tighten the lower control arm rear bolt to 98 Nm (72 ft. lbs.).
9. Remove the J 23028-01.
10. Install the shock absorber.
11. Install the stabilizer shaft link to the lower control arm.
12. Check the front wheel alignment.