Radio Replacement (With RPO Code UC6)

REMOVAL PROCEDURE




1. Remove the instrument panel accessory trim plate.
2. Remove the screws that secure the radio to the instrument panel.




3. Remove the radio from the support bracket enough to access the connectors at rear of the radio.
4. Disconnect the electrical connector (2) from the radio.
5. Remove the radio.

INSTALLATION PROCEDURE




1. Connect the electrical connector (2) to the radio.




2. Align the radio locator tab (1) into the locator hole.
3. Install the radio retaining screws.

Tighten
Tighten the radio retaining screws to 2 N.m (18 lb in).

4. Install the instrument panel accessory trim plate.
5. Recalibrate the new radio assembly. Refer to Radio Setup.