Blower Motor Replacement (C42)

REMOVAL PROCEDURE




1. Disconnect the PCM.
2. Remove the coolant reservoir.
3. Remove the rear coolant recovery reservoir mounting stud.
4. Disconnect the cooling tube from the blower motor.




5. Disconnect the electrical connector (1).
6. Remove the blower motor mounting bolts (2).
7. Remove the blower motor.

INSTALLATION PROCEDURE




1. Install the blower motor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the blower motor mounting bolts (2).

Tighten
Tighten the bolts to 4.5 N.m (40 lb in).

3. Connect the electrical connector (1).




4. Connect the cooling tube to the blower motor.
5. Install the rear coolant recovery reservoir mounting stud.
6. Install the coolant reservoir.
7. Install the PCM.

For a description of the RPO Code(s) shown in this article/images refer to the RPO Code List found at Vehicle/Application ID RPO Codes