Transmission Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector from the vehicle speed sensor.





3. Remove the following parts:
^ The vehicle speed sensor
^ The O-ring seal

Installation Procedure





1. Coat a new O-ring seal with a thin film of transmission oil.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the following parts:
2.1. The O-ring on the vehicle speed sensor assembly.
2.2. The vehicle speed sensor assembly.
2.3. Tighten the bolt to 16 Nm (12 ft. lbs.).





3. Install the electrical connector to the vehicle speed sensor.
4. Lower the vehicle.