Instrument Panel (IP) - Extension Replacement

IP Extension Replacement

Removal Procedure

1. Remove the caps that cover the extension screws.
2. Remove the screws from the extension.
3. Remove the nuts at the bottom of the extension.




4. Pull toward the rear of the vehicle in order to remove the extension from the instrument panel.
5. Disconnect the electrical connectors.



Installation Procedure

1. Connect the electrical connectors.




2. Install the extension to the instrument panel:

1. Align the retainers.
2. Press the extension into place until the retainers are seated.


Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the nuts that retain the extension to the floor.

Tighten the nuts that retain the extension to the floor to 8 N.m (71 lb in).

4. Install the retaining screws.

Tighten the screws to 8 N.m (71 lb in).

5. Install the extension screw covers.