Mode Door Replacement (Upper)

REMOVAL PROCEDURE




1. Remove the IP carrier.
2. Remove the heater module cover screws from the heater module (1).
3. Remove the heater module cover from the module.
4. Remove the mode door actuator and the linkage (1) Mode Actuator Replacement (Upper) or Mode Actuator Replacement (Lower).
5. Remove the upper mode door from the heater module (2).

INSTALLATION PROCEDURE




1. Install the upper mode door (2) to the heater module (1).
2. Install the heater module cover to the heater module (1).
3. Install the heater module cover screws to the heater module (1).

Tighten
Tighten screws to 1.9 N.m (17 lb in).

4. Install the upper mode linkage and actuator.
5. Install the IP carrier to the vehicle.