Ignition & Key Alarm Switch - Assemble

Ignition and Key Alarm Switch Assembly -Assemble - Off Vehicle




1. Install the ignition and key alarm switch assembly (1) onto the electronic lock module assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 tapping screws (2) into the ignition and key alarm switch assembly (1).
Tighten the screws to 1.5 Nm (13 inch lbs.).





3. Install the key alarm connector (1) into the electronic lock module assembly (2).
3.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
3.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).

Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.





5. Attach new wire harness straps to the wire harness assembly (1).
6. Attach the wire harness assembly (1) to the wire harness strap (2).
7. Install the upper and lower trim covers.
8. Enable the inflatable restraint steering wheel module.