Ignition Switch

Ignition Switch Replacement - On Vehicle

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system.
2. Remove the tilt lever.
3. Remove the trim covers from the column.
4. Remove the knee bolster.





5. Disconnect the steering column electrical connectors.
6. Remove the wire harness assembly (1) from the wire harness strap (2).
7. Remove and dispose of the smaller wire harness straps.





8. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





9. Remove the key alarm connector (1) from the lock module assembly (2).
9.1. Rotate the key alarm connector (1) 90 degrees.
9.2. Pull the key alarm connector (1) out of the lock module assembly (2).





10. Remove the 2 tapping screws (2) from the ignition and key alarm switch assembly (1).
11. Remove the ignition and key alarm switch assembly (1) from the lock module assembly.

Installation Procedure





1. Install the ignition and key alarm switch assembly (1) onto the lock module assembly.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 tapping screws (2) into the ignition and key alarm switch assembly (1).
Tighten the 2 tapping screws to 1.5 Nm (13 inch lbs.).





3. Install the key alarm connector (1) into the lock module assembly (2).
3.1. Push the key alarm connector (1) into the lock module assembly (2).
3.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
5. Connect the steering column electrical connectors.





6. Attach new wire harness straps to the wire harness assembly (1).
7. Attach the wire harness assembly (1) to the wire harness strap (2).
8. Install the knee bolster.
9. Install the trim covers to the column.
10. Install the tilt lever.
11. Enable the SIR system.