SIR Steering Wheel Module Coil - Assemble

Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle





1. Place the block tooth on the steering shaft assembly (1) in the 12 o'clock position.





2. Install the wave washer (1) onto the steering shaft assembly (2).

Important: A new inflatable restraint steering wheel module coil is pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until installation is complete.





3. If you are installing the existing coil, center the coil first.
4. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
5. Slide the new inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
6. Firmly seat the new retaining ring (3) into the groove on the steering shaft assembly (2).
7. Remove the centering tab from the new inflatable restraint steering wheel module coil (4).
8. Discard the centering tab.

Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.





9. Attach new wire harness straps to the wire harness assembly (1).
10. Attach the wire harness assembly (1) to the wire harness strap (2).
11. Install the upper and lower trim covers.
12. Enable the inflatable restraint steering wheel module.