Wiper Gear Box: Service and Repair
WIPER TRANSMISSION REPLACEMENTTOOLS REQUIRED
^ J 39232 Wiper Transmission Separator
^ J 39529 Wiper Transmission Installer
REMOVAL PROCEDURE
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the electrical connector from the wiper motor.
4. Remove the 4 bolts retaining the wiper system drive module
5. Remove the wiper system drive module from the vehicle.
6. Disconnect the drive link from the wiper motor crank arm using the J 39232.
7. Remove the 4 bolts retaining the wiper transmission.
8. Remove the wiper transmission from the wiper drive system module.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the wiper transmission onto the wiper drive system module with the 4 bolts.
Tighten
Tighten the bolts to 7 N.m (62 lb in).
2. Connect the drive link onto the wiper motor crank arm using the J 39529.
3. Install the wiper drive system module on the vehicle.
4. Install the 4 bolts.
Tighten
Tighten the bolts to 8 N.m (71 lb in).
5. Connect the electrical connector to the wiper motor.
6. Install the air inlet grille panel.
7. Install the wiper arms.
8. Operate the wipers and inspect for proper operation.