64. Engine Front Cover Installation

Engine Front Cover Installation

Notice: Refer to Fastener Notice in Service Precautions.

Important: Do not reuse the composite type engine front cover and seal. Always Install a NEW engine cover, which includes a new seal.





1. Install the NEW engine front cover and bolts.
^ Tighten the engine front cover bolts to 12 Nm (106 inch lbs.).





Important: DO NOT reuse the original crankshaft position sensor seal, O-ring. When Installing the crankshaft position sensor be sure the crankshaft position sensor is fully seated and held stationary in the engine front cover crankshaft position sensor bore. A crankshaft position sensor that is not completely seated will cock in the engine front cover and may result in erratic engine operation.

2. Lubricate the NEW crankshaft position sensor seal, O-ring, with clean engine oil.
3. Install the NEW crankshaft position sensor seal, O-ring, onto the crankshaft position sensor.





4. Install the crankshaft position sensor.
5. Install the crankshaft position sensor bolt.
^ Tighten the crankshaft position sensor bolt to 9 Nm (80 inch lbs.).