Front Lower

Lower Control Arm Replacement

Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.





3. Remove the coil spring.
4. Remove the lower ball joint from the Steering Knuckle.
5. Remove the lower control arm.

Installation Procedure
1. Install the lower ball joint to the steering knuckle.

Notice:
^ Avoid pounding the bolts or any excessive force when installing the control arm to the frame.
^ Always inspect the frame attachment hole for elongation greater than 1 mm clearance around the bolt in any direction at any location. If 1 mm gap or other evidence of damage is detected, repair the frame as required.





2. Install the coil spring.
3. Install the tire and wheel.

Notice: Refer to Fastener Notice in Service Precautions.

4. Lower the vehicle.
Tighten the lower control arm to the frame nuts to 155 Nm (115 ft. lbs.).
5. Check the wheel alignment.