89. Engine Wiring Harness Assembly Installation

Engine Wiring Harness Assembly Installation

^ Tools Required
- J 39083 Glow Plug Connector Tool
- J 41515-A Glow Plug Socket





1. Install the crankshaft position sensor in the front cover, if equipped.





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the crankshaft position sensor bolt, if equipped.
^ Tighten the crankshaft position sensor bolt to 23 Nm (17 ft. lbs.), if equipped.





3. Install the glow plugs using the J41515-A.
^ Tighten the glow plugs to 17 Nm (13 ft. lbs.).





4. Install the heat shields on cylinders number 4 and 6.
5. Using J 39083 Install the jumper wires to cylinders 4 and 6.





6. Place the harness in the engine valley.
7. Plug in or connect all the wiring harness connectors to devices or attachment points.