Shift Lever - With Tow/Haul Switch

SHIFT LEVER REPLACEMENT (WITH TOW/HAUL SWITCH)

REMOVAL PROCEDURE




1. Remove the 2 TORX(R) head screws from the lower column trim cover.
2. Remove the lower column trim cover.
3. Roll back the seal on the shift lever (1) until the TORX(R) head screw (2) is exposed.
4. Remove the TORX(R) head screw (2).
5. Remove the knee bolster.




6. Remove the nuts (1) from the knee bolster deflector bracket




7. Remove the wiring harness retaining pin (4) from the instrument panel.

NOTE: During removal of the steering column the wire harness retaining clip must be removed and reinstalled after installing the steering column or damage may occur to the wire harness.

8. Remove the wire straps and open the harness insulation to gain access to the electrical wiring.
9. Remove the wiring from the electrical connector.
10. Remove the shift lever (1).

INSTALLATION PROCEDURE




1. Install the shift lever (1).
2. Connect the shifter electrical connector.
3. Install the wire straps to the harness.




4. Install the harness retaining pin (4) to the instrument panel.




5. Install the knee bolster deflector bracket and nuts (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the nuts to 9 N.m (80 lb in).

6. Install the knee bolster.
7. Install the TORX(R) head screw.

Tighten
Tighten the screw to 1.5 N.m (13 lb in).

8. Roll the seal over the TORX(R) head screw.
9. Install the lower column trim cover.
10. Install the 2 TORX(R) head screws to the lower column trim cover.

Tighten
Tighten the screw to 3.5 N.m (31 lb in).