Ignition Lock Cylinder

IGNITION LOCK CYLINDER REPLACEMENT

REMOVAL PROCEDURE
1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
2. Remove the steering column trim covers.




3. Turn the ignition lock cylinder to the START position.
4. Using an awl, insert the tip into the access hole (1) of the ignition lock cylinder.
5. Push down and hold the lock cylinder retaining pin.
6. Release the lock cylinder to the RUN position.




7. Pull the lock cylinder away from the steering column.

INSTALLATION PROCEDURE




1. Install the ignition lock cylinder into the steering column using the following procedure:
1.1. Align the positioning locking tab slot on the ignition lock cylinder case assembly to the positioning tab on the ignition lock cylinder.
1.2. Push the lock cylinder in until the locking tab locks in the ignition lock cylinder case assembly.
2. Install the steering column trim covers.
3. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
4. Perform the PASSLOCK learn procedure. Service and Repair