Inflatable Restraint Instrument Panel Module Replacement

REMOVAL PROCEDURE
1. Remove upper I/P trim panel.
2. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 5.

CAUTION:
- Refer to SIR Caution in Service Precautions.
- Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.




3. Remove the connector from the I/P.
4. Remove the inflatable restraint I/P module retaining bolts.
5. Remove the inflatable restraint I/P module.
6. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period.

INSTALLATION PROCEDURE




1. Install the inflatable restraint I/P module to the mounting bracket through the front of the instrument panel.
2. Install the fasteners to the inflatable restraint I/P module. Install the top bolts first then the lower ones second.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the fasteners to 9 Nm (80 lb in).

3. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5.
4. Install the yellow connector to the I/P.
5. Install the upper I/P trim panel.