Rear Wheel Steering Gear Protection Shield Replacement
STEERING GEAR PROTECTION SHIELD REPLACEMENTREMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.
NOTE: Refer to Rear Wheel Steering Lifting and Jacking Notice in Service Precautions.
2. Remove the bolts (3) retaining the steering gear protection shield to the steering gear.
3. Remove the steering gear protection shield from the vehicle.
INSTALLATION PROCEDURE
1. Install the steering gear protection shield to the steering gear.
2. Install the steering gear protection shield retaining bolts (3) to the steering gear.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolts to 180 N.m (132 lb ft).
3. Lower the vehicle.
4. Perform a four wheel alignment. Refer to Measuring Wheel Alignment (With Rear Wheel Steering) Measuring Wheel Alignment (Without Rear Wheel Steering) in Wheel Alignment.