Intermediate Steering Shaft Replacement - Lower
Intermediate Steering Shaft Replacement - LowerTools Required
^ J42640 Steering Column Lock Pin
Removal Procedure
Notice: The front wheels of the vehicle must be maintained in the straight ahead position and the steering column must be in the LOCK position before disconnecting the steering column or intermediate shaft. Failure to follow these procedures will cause improper alignment of some components during installation and result in damage to the SIR coil assembly.
1. Turn the steering wheel so that the front wheels are pointing straight ahead.
2. Turn the ignition switch to the lock position and remove the key.
3. Lock the steering column through the access hole in the lower steering column trim cover using J42640.
4. Disconnect the upper intermediate shaft boot from the lower intermediate shaft boot to gain access to the upper intermediate shaft to lower intermediate pinch bolt.
5. Remove the lower intermediate shaft to upper intermediate shaft pinch bolt.
6. Disconnect the lower intermediate shaft from the upper intermediate shaft.
7. Disconnect the lower intermediate shaft boot from the power steering gear and remove lower intermediate shaft boot from the vehicle.
8. Raise and support the vehicle.
Important: Note the relationship of the intermediate shaft to the power steering gear and the intermediate shaft to the steering column in order to ensure proper installation.
9. Remove the lower intermediate shaft to the power steering gear input shaft pinch bolt.
10. Disconnect the lower intermediate shaft from the power steering gear.
11. Remove the lower intermediate shaft from the vehicle.
Installation Procedure
1. Install the lower intermediate shaft to the vehicle.
2. Connect the lower intermediate shaft to the power steering gear.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the lower intermediate shaft to the power steering gear input shaft pinch bolt.
Tighten the lower intermediate shaft to the power steering gear input shaft pinch bolt to 40 Nm (29 ft. lbs.).
4. Lower the vehicle.
5. Install the lower intermediate shaft boot and connect the lower intermediate shaft boot to the power steering gear.
6. Connect the lower intermediate shaft to the upper intermediate shaft.
Notice: Refer to Fastener Notice in Service Precautions.
7. install the lower intermediate shaft to the upper intermediate shaft pinch bolt.
Tighten the lower intermediate shaft to the upper intermediate shaft pinch bolt to 50 Nm (37 ft. lbs.).
Important: The upper intermediate shaft boot must completely cover the white insert of the lower intermediate shaft boot to ensure proper sealing.
8. Connect the upper intermediate shaft boot to the lower intermediate shaft boot.
9. Unlock the steering column by removing J42640 from the steering column lower trim cover access hole.