Primary

HVAC CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE







1. Remove the IP accessory trim plate.
2. Remove the control module retaining screws.
3. Depress the HVAC control module retaining tabs (3) and remove the HVAC control module (2) from the instrument panel (4).
4. Disconnect the electrical connectors (1) from the HVAC control module (2).


INSTALLATION PROCEDURE







1. Connect the electrical connectors to the HVAC control module (2).

IMPORTANT: The Key should be in the off position when connecting the electrical connectors to ensure proper calibration.







2. Install the HVAC control module (2) to the instrument panel (4), ensuring that the HVAC control module retaining tabs (3) lock into place.
3. Install the HVAC control module retaining screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to .....1.9 N.m (17 lb ft).

4. Install the IP accessory trim plate.
5. Start the vehicle and let run for one minute.

IMPORTANT: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating.If interrupted improper HVAC performance will result.