Tail Lamp: Service and Repair
TAIL LAMP REPLACEMENTREMOVAL PROCEDURE
1. Remove the 2 screws that retain the tail lamp assembly to the body.
2. Pull the assembly directly rearward in order to release the 2 locking pins.
3. Disconnect the tail lamp electrical connector.
4. Remove the lamp assembly from the vehicle.
5. Remove the 2 socket assembly retaining screws.
6. Simultaneously release the bottom 4 locking tabs and partially remove the socket assembly.
7. Release the top 2 locking tabs and remove the socket assembly from the tail lamp assembly.
INSTALLATION PROCEDURE
1. Position the socket assembly to the tail lamp assembly.
2. Hold the top 2 locking tabs apart while pushing the socket assembly into place.
3. Hold the bottom 4 locking tabs apart while pushing the socket assembly into place.
4. Verify that the housing is fully seated with the locking tabs fully seated.
5. Install the 2 socket assembly retaining screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).
6. Connect the tail lamp electrical connector.
7. Push the tail lamp assembly directly forward in order to seat the 2 locking pins.
8. Install the 2 tail lamp assembly retaining screws.
Tighten
Tighten the screws to 1.9 N.m (17 lb in).